This simple set for 3D printer base on microcontroller Mega 2560 + RAMPS 1.4 + motor drivers, it is a solution for RepRap projects.
Uno R3 - compatible with Arduino Uno R3 board. Built on the Atmel ATmega328 microcontroller and USB-UART interface chip CH340G.
Board for functionality similar to the Arduino Uno (ATmega 168/328). It is a budget, but the same stable, and uses the original chips Atmel ATmega (16 MHz).
The board used the chip CH340G as converter UART-USB. Chip CH340G - is a budget solution. When you work in the frequency 12Mhz, giving a stable result of data exchange (need install drivers to computer).
Uno R3 - connects to the computer via micro USB cable (used for almost all Android smartphones).
You can supply power to board through the Micro USB connector or DC-jack. The voltage regulator (LDO) can deal with incoming voltage from 6V to 12V DC. Output current for 5V - about 800mA, for 3.3V - about 180mA (Please note that the higher the input voltage the lower the outgoing current). That will provide a reliable power most of your initial projects. We recomiende supply 7-9V.
Microcontroller | ATMega328 |
USB-TTL converter | CH340G |
Power Out | 5V-800mA |
Power IN. USB | 3.3V (180mA max.) |
Power IN. VIN/DC Jack | 7-9V |
Power Consumption | 5V 800mA |
Logic Level | 5V |
USB | Micro USB |
Clock Frequency | 16MHzMHz |
Operating Supply Voltage | 5V |
Digital I/O | 14(6-PWM) |
Analog I/O | 8 |
Memory Size | 16Kb/32 Kb |
Data RAM Type/Size | 2Kb |
Data ROM Type/Size | 1Kb |
Interface Type | ISP |
Operating temperature | −40С°/+85С° |
Length×Width | 53.34×68.58mm |
Weight | 8 |